If you are looking for the USB court reporter microphones, click here.

The Sound Professionals court reporter high sensitivity Omnidirectional microphone is very small - roughly 3/8" in diameter X 1/2" long. Because of it's high sensitivity, the microphone will pick up all of the sounds in an average courtroom very well. The microphone element is mounted in a high quality brass shell covered in tough black rubber. The microphone cartridge is very rugged and hand crafted to insure a lifetime of accurate recordings. A flexible high quality shielded cable is attached at the base of the microphone and will stand up to years of rough use. The cable is terminated in a 3.5mm (1/8") high quality right angle gold plated male connector. The cable length can be custom selected above in the option drop-down box. Cable length is measured from the bottom of the microphone capsule to the point where the cable enters the connector. It does not include the length of the microphone or connector.

Also included with the microphone is the necessary hardware that will allow you to attach it with either self adhesive velcro or a removable clip - you get both, so it's your choice which one you use!

Specifications:

- Signal To Noise Ratio: 62 dB, 1 kHz at 1 Pa - Dynamic Range: 81dB - Frequency Response: 20 - 20,000 Hz - Open Circuit Sensitivity: -35 dB (5.6 mV) re 1V at 1 Pa - Maximum Input Sound Level: 105 dB SPL, 1 kHz at 1% T.H.D.

Features:

- Flat frequency response - High Sensitivity - Can be used directly with a recorder or computer that provides 1.5 to 12vdc "plug-in-power" or with one of our microphone power modules

Warranty Information

Closeup of super-rugged right angle connector

Closeup of velcro fastener

Closeup of clip

Microphone shown attached to computer with clip

Alternate part numbers and similiar products: Labtec PC Mic 333, Labtec-PC-Mic-333, Labtec PC Mic333