Reward points:
Purchasing this will earn you 603000 rewards points! See the Policies page for details.

Description:

Manufacturer's website

Download Manual

---

Features:
Ethernet control is standard
Low-Z, 25V, 70V and 100V Models
Extensive DSP Available
Easy and intuitive user interface
Extensive protection circuitry
Safety/Compliance: (cTUVus/FCC, CE pending), RoHS
Level attenuators for each channel
Power switch can be disabled by software
4-Step Signal Level and Clip LEDs
10/100 Ethernet port
Euroblock inputs and outputs
Remote level control
Remote power standby

---

Ashly's two-channel NE amplifiers for the performance installation and constant voltage markets, the ne800, ne1600 and the ne2400 add a new level of power and control from the simplest to most advanced audio system applications. The ne800 provides 400W, ne1600 800W and ne2400 1200W per channel at four ohms. Input connections are XLR-1/4 inch Neutrik combo connectors and 6-pin Euroblock. XLR male and Euroblock connectors are also provided for looping to additional amplifiers. Output connectors are locking Neutrik Speakon (NL-4) and Euroblock.

Network Enabled (NE) amplifiers offer ease of use, full setup, control and monitoring using standard 10/100 Ethernet protocol and Protea NE Software. No special outboard control units are needed. NE Series amplifiers are offered two ways; standard and pe (Protea Enabled) with our world renowned Protea DSP signal processing.

The DSP library is extensive and utilizes two SHARC 32-bit/96kHz processors. Processing blocks include Graphic, Parametric, Notch and Shelving Equalization, High-, Low- and All-Pass Filters (HPF/LPF/APF) with up to 48dB/Octave slopes, Delay, Compressor/Limiter, Gate, Ducking, Auto-leveler, Gain and Signal Generators (sinewave, white and pink noise). A full Matrix Mixer with assignable routing allows any input to drive any or all amplifier outputs. Presets can be used to store and retrieve global parameters of an entire amplifier's control surface and DSP section.

Additionally, each amplifier also provides DC voltage control of the attenuators which makes it a snap to control volume from remote locations, preset recall, Remote Power Standby and data in and out ports for connecting accessories like the WR-5 to control user selected parameters. There are LED indicators for power, standby, protect, network communications and each channel has a four-step signal meter, bridge mono, temperature and current indicators. AES/EBU, and Cobranet input modules will be available as options.

---

Alternate part numbers and similiar products: ne2400ped, ne2400pec, ne2400pee